Martin punisher x250 manual

Powered by Blogger. Labels Puzzles Vol. NET 3. Seller Report item - opens in a new window or tab. Seller assumes all responsibility for this listing. Item specifics. Seller Notes:. Light Source:. Effect Light Fixture. Punisher XUS. Lighting Effects:. Shipping and handling. This item will ship to Germany , but the seller has not specified shipping options. Contact the seller - opens in a new window or tab and request a shipping method to your location.

Shipping cost cannot be calculated. Please enter a valid ZIP Code. No additional import charges at delivery! This item will be shipped through the Global Shipping Program and includes international tracking. Learn more - opens in a new window or tab. There are 1 items available. Please enter a number less than or equal to 1. Select a valid country.

Please enter 5 or 9 numbers for the ZIP Code. Press and hold [Store] and the up arrow button. Apply power. Press and hold [Midi] and the down arrow button.

Connect controller. Blackout or standby mode selected. Press blackout button. Bad data link connection. Swap pins 2 and 3. See section 2. DMX signal reflection. Insert termination plug in the last light on the link. Incorrect addressing of fixtures. Check addresses.

Fixtures not on. Turn on fixtures. Protocol auto-detection failure. Switch the fixtures off and then back on. In general, power on the controller before the fixtures. Save commands do not work. Memory locked. Unlock memory. Fixtures do not execute programming on one or more channels. Fader control is overriding programming. Turn off fader control. No light from some or all fixtures. Uneven or incomplete fader control. Faders not calibrated.

None of the fixtures respond to the controller. Some fixtures do not respond, respond erratically, or continuously reset. The reading should be around ohms. Readings from - 20, ohms indicate the data link is not terminated. Infinite resistance indicates a bad connection, broken wire, or a defective fixture. Very low readings indicate a short circuit in the link or a defective fixture. Press and hold [Blackout] to put the controller in standby mode.

Slide all six faders to the top. Press [Blackout] to bring the controller out of standby mode. Quickly press scene buttons 4 and 6 at the same time and hold for 1 second. Release the scene buttons. The channel LEDs chase upwards. Repeat steps if the LED chase does not occur. In controllers with CPU firmware version 2. If your controller has firmware version 1.

When a fader is at 0, the display reads 0 DMX 0. Do not leave a fader on 0 - you will not be able to read the other fader values. Press a DMX Channel button to complete the process and return to normal operation.

Press scene no. Save flash scene Press [Store]. Press [Midi]. Execute flash scene Press [Midi]. Set auto-trigger Press [Auto]. Toggle music trigger Press [Music]. Set show mode banks Press [Up] or [Down]. Set show mode loops Press a scene button from 1 to 6. Blackout Press [Blackout]. Standby Press-and-hold [Blackout]. Clear blackout or standby Press [Blackout]. Save auto-start configuration Press-and-hold channel master. Toggle tandem mode Put both controllers on standby. Press [Blackout] on bottom controller.

Press [Blackout] on top controller. Next Page. All rights reserved. Printed in Denmark. With a motorized parabolic reflector and gobo wheel, they produce a myriad of turning beams that change color and pattern on demand. Page 4: Safety Information If you have questions about how to operate the fixture safely, please contact a Martin distributor for assistance. Do not install any other lamp.

Allow the unit to cool for 15 minutes before handling. You will have to fit a plug that conforms to your local mains outlet.